BS EN 73 pdf free download
BS EN 73-2020 pdf free download.Durability of wood and wood-based products – Accelerated ageing of treated wood prior to biological testing一Evaporative ageing procedure.
6 Test specimens
6.1 Definition and origin
The test specimens and their preparation are defined in the standards concerning the biological tests to which they are intended to be subjected.
Prior to testing the specimens may be stored at (20 ± 2) °C and (65 ± 5) % relative humidity. Deviation from this must be stated in the biological report.
6.2 Number of test specimens
The number of test specimens shall allow the relevant biological tests to be carried out in accordance with the instructions in the appropriate standards, bearing in mind that in some tests the evaporative ageing procedure shall be applied to control specimens as well as to test specimens.
The control specimens may be of the following kinds where required by the relevant test standard:
— check test specimens that will not be subjected to attack by biological agents after the evaporative ageing procedure. These will serve as controls for changes in mass in those tests in which this factor Is taken into consideration;
— untreated control or reference species specimens which, after evaporative ageing, are subjected to the test by biological agents to check any variation in the behaviour of the reference species.
7 Procedure
7.1 Arrangement of the test specimens
Arrange the test specimens in the compartments on grids made from metal or any other inert material which can be decontaminated, resting them with one of their faces on the base so that none of the other faces is less than 10 mm from the side partitions. The faces parallel to the grain of the wood shall be parallel to the general direction of air flow and they shall be at least 10 mm from the corresponding faces of the adjacent test specimens. Do not place in the same compartment test specimens of different species, specimens treated with different products or with different concentrations or loadings of the same product, specimens from wood modified using different processes or to different extents, or both test and control specimens:
— test specimens
The arrangement of the test specimens may vary from that described above in the following cases:
— test specimens for which the faces perpendicular to the grain of wood are sealed before treatment
Arrange the test specimens as above. The sealed faces may, however, be brought closer together.
For example, specimens intended for testing in accordance with EN 118 (termites).
— test specimens with one treated face only
Rest the test specimens on the opposite face to that which has been treated.
For example, test specimens intended for the test determining preventive action against termites (EN 118) and the larvae of Hylotrupes bajulus (EN42).
7.2 Starting and adjustment of the apparatus
With the test specimens in position, establish an air current controlled at a temperature of (40 ± 2) °C which enters the compartments at a speed of (1 ± 0,3) rn/s.BS EN 73 pdf download.
