BS EN 4612-005 pdf free download
BS EN 4612-005-2019 pdf free download.Aerospace series – Cables, electrical, for general purpose, single and multicore assembly – XLETFE Family – Jacketed or screened and jacketed Part 005: Tin plated copper – Operating temperatures, between – 65°C and 135°C – Dual extruded wall for open applications, with jacket without screen – UV laser printable – Product standard.
This document specifies the characteristics of UV laser printable jacket, tin plated copper conductor, electrical cables, Crosslinked Ethylene Tetra Fluoro Ethylene co-polymer XLETFE family for use in the on-board electrical systems of aircraft at operating temperatures between – 65 °C and 135 °C operating at voltages not exceeding 600 V rms at sea level. This insulation system has been used in aerospace applications using 115 V (phase-to-neutral) 400 Hz ac and 28 Vdc. Verification of the suitability of cables for use in other electrical systems is the responsibility of the user.
These cables are suitable for airframe use without additional protection. In case of conflict between this standard and other referenced documents the requirements of this standard shall take precedence.
2 Normative references
The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
EN 2235, Aerospace series — Single and multicore electrical cables, screened and jacketed — Technical specification
EN 3475-100 (all parts), Aerospace series — Cables, electrical, aircraft use — Test methods — Part 100: General
EN 4611-004, Aerospace series — Cables, electrical, for general purpose, single and multicore assembly —
XLETFE Family — Part 004: Tin plated copper — Operating temperatures, between – 65 °C and 135 °C — Dual extruded wall for open applications — UV laser printable — Product standard
EN 4612-002, Aerospace series — Cables electrical, for general purpose, single and multicore assembly — XLETFE Family — Jacketed or screened and jacketed — Part 002: General
EN 9133, Aerospace series — Quality Management Systems — Qualification Procedure for Aerospace Standard Products
3 Terms, definitions and symbols
For the purposes of this document, the terms, definitions and symbols given in EN 3475-100 apply.
ISO and IEC maintain terminological databases for use in standardization at the following addresses:
• IEC Electropedia: available at http://www.electropedia.org/
• ISO Online browsing platform: available at http://www.iso.org/obp
4 Materials and construction
4.1 Materials
These cables shall consist of the following:
• cores according to EN 4611-004;
• number of cores 2 (two) to 4 (four).
Cores be twisted together according to EN 2235.
Filler cores shall not be permitted.
Outer jacket:
• it shall be possible to mark the jacket by UV laser printing;
• minimum thickness shall be 0,15 mm.
4.2 Construction
See Table 1.BS EN 4612-005 pdf download.
