BS EN 13497 pdf free download
BS EN 13497-2021 pdf free download.Thermal insulation products for building applications一Determination of the resistance to impact of external thermal insulation composite systems (ETICS).
This European Standard specifies the equipment and procedure for determining the resistance to impact of design ETICS kits with renders.
2 Normative references
The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
EN 1602, Thermal insulating products for building applications — Determination of the apparent density
EN 1607, Thermal insulating products for building applications — Determination of tensile strength perpendicular to faces
EN 16383, Thermal insulation products for building applications — Determination of the hygrothermal behaviour of external thermal insulation composite systems with renders (ETICS)
EN 17237, Thermal insulation products for buildings — External thermal insulation composite systems with renders (ETICS) —Specification’
EN ISO 9229, Thermal insulation — Vocabulaty fiSO 9229)
ISO 3290-1, Rolling bearings — Balls — Part 1: Steel balls
3 Terms and definitions
For the purposes of this document, the terms and definitions given in EN ISO 9229 and EN 17237 apply. ISO and IEC maintain terminological databases for use in standardization at the following addresses:
— IEC Electropedia: available at http://www.electropedia.org/
— ISO Online browsing platform: available at http://www.iso.orglobp
4 Principle
The impact resistance of a design ETICS kit is the hard body impact resistance, determined by means of a steel ball falling onto the surface of the kit. The energy level and corresponding dropping height is selected from Table 1. Any damages occurring are visibly assessed (e.g. the reinforcement has become visible from the external surface, the finishing coat or the rendering system has visibly delaminated or been perforated) and cracks widths are measured.
1 To be published. Stage at the time of publication: prEN 17237:2018.
5 Test apparatus
5.1 General
For the test a steel ball is dropped from a specified height onto the surface of the test specimen (see Table 1). A second impact (rebound) by the ball shall be avoided.
5.2 Steel ball requirements
Balls made of cutlery grade steel, AISI/SE Type 440 C and grade G100 according to ISO 3290-1 with the weights and nominal diameters given in Table 1.
5.3 Crack measuring gauge
For measurement of the width of any cracks formed as a result of the impact of the steel ball onto the surface of the test specimen. The gauge shall be capable measuring from 0,1 mm and be graduated in steps of 0,05 mm.
5.4 Specimen support
The support itself shall be flat, not bend, deform or absorb impact energy during the test, e.g. concrete support, in order not to influence the test result. E The test specimen shall be firmly held to prevent movement during the test. €iI
NOTE 1 Larger specimen tends to show less movement than smaller specimen.
NOTE 2 The specimen might be fixed, clamped or glued to the support so that contact between them is maintained during the test.
5.5 Optional tube to control descent of steel ball
A vertical tube manufactured from a metal or rigid plastic can be used for this purpose with an inner diameter at least 2 mm larger than the steel ball diameter. The walls of the tube should preferably include regular perforated holes to prevent air within the tube becoming compressed due to the velocity of the ball during its descent and thereby acting as a resistance cushions to the impact of the ball with the specimen surface.BS EN 13497 pdf download.
