BS 7273-6 pdf free download
BS 7273-6-2019 pdf free download.Code of practice for the operation of fire protection measures Part 6: Fire detection and fire alarm systems – Interface with ancillary systems and equipment.
This part of BS 7273 gives recommendations for the design, installation, commissioning and maintenance of interface arrangements between fire detection and fire alarm systems conforming to BS 5839‑1:2017 and various ancillary systems and equipment (ASE), where this interface is required by the fire strategy for a building, excluding the interface with those systems covered in other parts of the BS 7273 series.
Arrangements covered by this part of BS 7273 include the interface between fire detection and fire alarm systems and:
• smoke control systems;
• lifts and other lifting appliances;
• gas valves;
• fire‑resisting shutters and active fire curtain barrier assemblies;
• electricity supplies;
• ventilation systems;
• lighting, intelligent signage and wayfinding; and
• paging systems.
This part of BS 7273 does not apply to the interface between ASE contained solely within a private dwelling and the fire detection and fire alarm system within that dwelling. It applies to systems installed in the common parts of blocks of flats (e.g. activation of the smoke control system), and where the actuation of the detection within a dwelling is intended to interact with a system within common parts (such as in sheltered housing).
The scope of this part of BS 7273 is shown diagrammatically in Figure 1.
2 Normative references
The following documents are referred to in the text in such a way that some or all of their content constitutes provisions of this document 1 . For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
BS 5266- 1, Emergency lighting – Part 1: Code of practice for the emergency lighting of premises
BS 5839-1:2017, Fire detection and fire alarm systems for buildings – Part 1: Code of practice for design, installation, commissioning and maintenance of systems in non-domestic premises
BS 6724, Electric cables一Thermosetting insulated, armoured cables of rated voltages of 600/1 000 V and 1 900/3 300 V for fixed installations, having low emission of smoke and corrosive gases when affected by fire一Specification
BS 7346-8, Components for smoke control systems一Part 8: Code of practice for planning, design, installation, commissioning and maintenance
BS 7671, Requirements for Electrical Installations一IET Wiring Regulations
BS 7846, Electric cables – Termosetting insulated, armoured, fire-resistant cables of rated voltage 600/1 000 V for fixed installations, having low emission of smoke and corrosive gases when affected by fire一Specification
BS 9999, Fire safety in the design, management and use of buildings一Code of practice?
BS EN 54-4, Fire detection and fire alarm systems – Part 4: Power supply equipment
BS EN 1838, Lighting applications – Emergency lighting
BS EN 12101 (all parts), Smoke and heat control systems
BS EN 50172 (BS 5266-8), Emergency escape lighting systems
BS EN 60702-1, Mineral insulated cables and their terminations with a rated voltage not exceeding 750 V- Part 1: Cables
ETSI EN 300 220-1, Short Range Devices (SRD) operating in the frequency range 25 MHz to 1 000 MHz – Part 1: Technical characteristics and methods of measurement
ETSI EN 300220-2, Short Range Devices (SRD) operating in the firequency range 25 MHz to 1000 MHz – Part 2: Harmonised Standard covering the essential requirements of article 3.2 of
Directive 2014/53/EUfor non-specific radio equipment
ETSI EN 300 224, Land Mobile Service – Radio equipment for use in a paging service operating within the frequency range 25 MHz – 470 MHz – Harmonised Standard covering the essential requirements of article 3.2 of Directive 2014/53/EU.BS 7273-6 pdf download.
